Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Removing
– Remove the door trim ⇒ page 189 .
– Remove the insulation ⇒ page 192 .
– Unplug the connector -1-.
– Unplug the connector -2-.
– Unscrew the bolts -4- (2x).
♦ Tightening torque 2 Nm.
– Take out the interior door handle on the front side of the door
trim.
♦ Installing
– Make sure the cable of the connector -2- is positioned behind
the holder -3-.
– Install the interior door handle in the reverse order of removal.
2.13 Removing and installing hinged pocket
with mount
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
196 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
