Audi A8 2003 - Removing and Installing Rear Left Seat V127 and Rear Right V128 Lumbar Support Longitudinal Adjustment Motor with Four-Way Lumbar Support

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.23 Removing and installing rear left seat -V127- and rear right -V128- lumbar
support longitudinal adjustment motor with four-way lumbar support
1 - Upper clip (2x)
2 - Bowden cable
3 - Clip
4 - 4-way lumbar support
5 - Spring lock washer
6 - Hook
7 - Lower clip (2x)
8 - Rear left seat -V127- and
rear right -V128- lumbar sup‐
port longitudinal adjustment
motor
♦ Removing
– Remove the seat pan
⇒ page 342 .
– Remove the individual
rear seat ⇒ page 343 .
– Unplug the connector
-9-.
– Disengage the Bowden
cable -2- from the clip
-3-.
– Prise out the lock wash‐
er -5-.
– Disengage the Bowden
cable -2- at the hook
-6-.
– Disengage the upper
clips -1- (2x) from the
backrest frame -10-.
– Disengage the lower
clips -7- (2x) from the
backrest frame -10-.
– Take out the lumbar
support adjustment mo‐
tor -8- with the 4-way
lumbar support -4-.
♦ Installing
– Install the lumbar support adjustment motor -8- in the reverse order of removal.
9 - Connector
10 - Backrest frame
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
356 Rep. gr.72 - Seat frames