Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
WARNING
There must not be any‐
one in the vehicle when
connecting the battery.
– With the ignition switched on, connect the battery earth wire ⇒ Electrical system; Rep. gr. 27 .
– Check the belt-fastened sensor ⇒ page 105 .
9 - Bolt
❑ Tightening torque 55 Nm.
2.6 Removing and installing third rear three-
point seat belt (fixed rear seat backrest)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Seat belts 111