Audi A8 2003 - Removing and Installing Lumbar Support Adjustment Motors

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.29 Removing and installing lumbar support
adjustment motors
Note
On the front passenger's seat shown, the lumbar support height
adjustment motor is on the right and the lumbar support adjust‐
ment motor on the left.
1 - Bowden cable for lumbar
support adjustment
2 - Bowden cable for lumbar
support height adjustment
3 - 4-way lumbar support
4 - Hook
5 - Retainer
6 - Guide roller
7 - Cap nuts (3x)
8 - Cable tie
9 - Connector
10 - Cable tie
11 - Lumber support adjust‐
ment motors (2x)
❑ Remove the seat
⇒ page 282 .
❑ Attach the holder for
seat repair -VAS 6136-
to the engine and gear‐
box holder -VAS 6095- .
❑ Attach the front seat to
the holder for seat repair
-VAS 6136- .
❑ Remove the upper
backrest cover panel
⇒ page 309 .
❑ Remove the lower back‐
rest cover panel
⇒ page 310 .
❑ Unfasten the cable ties
-8- and -10-.
❑ Unplug the connector
-9-.
❑ Unscrew the cap nuts -7- (3x).
❑ Remove the motor on the other side in the same manner.
❑ Disengage the Bowden cable for lumbar support height adjustment -1- at the hook -4-.
❑ Disengage the Bowden cable for lumbar support adjustment -2- at the retainer -5- and at the guide roller
-6-.
❑ Remove the lumbar support motors (2x).
♦ Installing
♦ Install the lumbar support adjustment motors -11- in the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
312 Rep. gr.72 - Seat frames