Audi A8 2003 - Removing and Installing Extension for Centre Console

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– When fitting trim panel -1- with switch panel make sure both
catches are inserted in centre of trim panel between dash
panel and monitor housing -arrows-.
– With ignition switched on, connect battery earth wire ⇒ Elec‐
trical system; Rep. gr. 27 .
Tightening torques
Component Nm
Centre console to: Body 4
Dash
panel
4
Split armrest to support 18
Air vents to rear centre console 2.5
Storage compartment (driver side) Central
tube
4
to:
Dash
panel
4
Glove box to: Central
tube
4
Dash
panel
4
3.4 Removing and installing extension for
centre console
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Removing and installing centre console with extension 59