Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Use screwdriver, for example, to press on rocker -A- of selec‐
tor lever manual release mechanism.
– At the same time, move selector lever from „P“ to „D“.
– Turn collar -1- to left and push it down as far as it will go.
– Lift off knob -2- for selector lever.
– Release fasteners -1- on either side of shift mechanism
-arrow- and lift up trim panel -3-.
– Unplug electrical connector -2- and detach trim panel.
– Raise centre console at rear and unplug connectors on un‐
derside of centre console.
– Detach centre console towards rear.
Installing
Installation is carried out in reverse order; note the following:
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
58 Rep. gr.68 - Interior equipment
To Next Page
Loading...
