Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.3 Removing and installing bracket for cen‐
tre armrest
Removing
– Remove centre armrest ⇒ page 75 .
– Starting at bottom -arrow-, carefully prise cover -1- off padding
-2-.
– Take out cover.
– Press down retaining tabs -1-.
– At the same time, press carrier -2- in direction of -arrow- until
lugs of carrier are disengaged from guides of padding -3-.
– Take bracket with carrier out of padding.
– Prise off securing clip -1-.
– Remove pins -2-. Use mandrel if necessary.
– Prise off securing clip -6-.
– Remove pin -7-. Use mandrel if necessary.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
78 Rep. gr.68 - Interior equipment
To Next Page
Loading...
