Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5.9 Removing and installing storage com‐
partment light
Removing
– Remove centre armrest (split) ⇒ page 84 .
– Remove storage compartment -1- ⇒ page 88 .
– Unclip light -2-.
– Unfasten adhesive strips.
– Remove speed nut -1-.
2 - Wire for storage compartment light
– Take wires -1- and -2- out of locators -arrow-.
Installing
Installation is carried out in reverse order; note the following:
– Route wires in locators at support for split centre armrest.
– Fix wires in position with adhesive tape.
– Make sure wires are neither trapped nor strained as centre
armrests move.
5.10 Separating centre armrest (split)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
90 Rep. gr.68 - Interior equipment