Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2 Removing and installing glove box/knee bolster
Special tools and workshop
equipment required
♦ Removal wedge -3409-
♦ Protective cap -
VAS 6223/9-
♦ Radio release tool -
T10057-
Removing
WARNING
Observe safety regulations for pyrotechnic components
⇒ page 94 .
– Vehicles with knee airbag: With ignition switched on, discon‐
nect battery earth wire ⇒ Electrical system; Rep. gr. 27 .
– Use screwdriver to prise off dash panel end trim (right-side)
-arrow-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Shelves / trim panels 5
To Next Page
Loading...
