Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Carefully pull off the defroster vent -1- with the front end hook
-3370- in -arrow direction-.
Installing
– Engage the hooks -1- of the defroster vent in the dash panel
opening.
– Then engage the defroster vent -3- in the dash panel with the
retaining spring -2-.
3.9 Removing and installing sunlight pene‐
tration photosensor -G107- with cap
Special tools and workshop equipment required
♦ Feeler gauge
Removing
– Unclip the cap -1- with a 0.35 mm feeler gauge -2- from the
centre defroster vent -arrow-.
– Prise out the sunlight penetration photosensor -G107-
-Item 3- and unplug the connector.
Installing
Install in reverse order.
3.10 Removing and installing centre defrost‐
er vent
Special tools and workshop equipment required
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
220 Rep. gr.70 - Trim, insulation