Audi A8 2003 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.3 Removing head restraint guides with
backrest in position
Note
For greater clarity, the head restraint guide -1- has been removed
in the illustration.
♦ Removing
– Insert an upholstery needle or screwdriver -3- with a max.
width of 2 mm in the hole -4- (the hole -4- is located opposite
the fastener of the head restraint guide).
– Applying a screwdriver -3- in the direction of arrow -A-, press
the retainer tab -2- in the direction of arrow -B- and pull out the
head restraint guide -1-.
♦ Installing
– Make sure the head restraint guides with buttons are installed
on the left side in the direction of travel.
2.4 Removing head restraint guides with
backrest removed
♦ Removing
– Remove the head restraint ⇒ page 337 .
– Press the padding -3- upwards in arrow direction.
Note
The openings for applying the screwdriver are always to be found
on the outside.
– Use a screwdriver to prise out the head restraint guide -2- up‐
wards through the opening -1-.
– Lift out the head restraint guide -2-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Rear seat covers and padding 375

Audi A8 2003 Specifications

General

Brand	Audi
Model	A8 2003
Category	Automobile
Language	English