Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Removal wedge -3409-
♦ Feeler gauge
Removing
– Unclip the cap -1- with a 0.35 mm feeler gauge -2- from the
centre defroster vent -arrow-.
– Prise out the sunlight penetration photosensor -G107-
-Item 3- and unplug the connector.
– Screw out the bolt -1-.
– Prise the centre defroster vent -2- as shown out of the dash
panel using the removal wedge -3409- .
Installing
Install in reverse order.
Tightening torque:
Centre defroster vent to dash panel: 2 Nm
3.11 Removing and installing indirect ventila‐
tion trim panel
Special tools and workshop equipment required
♦ Removal wedge -3409-
♦ Feeler gauge
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Dash panel 221
To Next Page
Loading...
