Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1783-
– Use a screwdriver to prise out the cap -3-.
– Unscrew the bolts -2- (2x).
♦ Tightening torque 4 Nm.
– Detach the mount -1-.
5.4 Removing and installing roof reinforce‐
ment
Note
♦
Only fitted on vehicles with no sun roof.
♦
The brackets for attaching the moulded headliner at the front
-3- and rear -4- are bonded to the roof reinforcement and can‐
not be replaced separately.
Removing
– Remove the moulded headliner ⇒ page 245 .
– Starting at the rear, carefully detach the roof reinforcement
-1- from the roof.
Installing
– Apply new adhesive between the adhesive beads -2-.
– New roof: Apply adhesive at the recesses -2-.
– Use the adhesive with genuine part number: D 190 MKD A3.
– Wait at least 2 hours before fitting the moulded headliner.
5 - For series assembly only (can be ignored)
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
248 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
