Audi A8 2003 - Interior Mirror; Removing and Installing Interior Mirror

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6 Interior mirror
Overview
♦ ⇒ „6.1 Removing and installing interior mirror“, page 92
♦ ⇒ „6.2 Checking operation of automatic anti-dazzle interior
mirror“, page 93
6.1 Removing and installing interior mirror
Note
♦ Mirror must be removed if ball joint is not clipped in.
♦ Ball joint must be clipped in whilst removed, at the same time feeding through wiring harness.
1 - Interior mirror
❑ With automatic anti-
dazzle function
Removing
– Remove roof module
(front) ⇒ Electrical sys‐
tem; Rep. gr. 96 .
– Unplug connector of
wire -4- from roof mod‐
ule (front).
– Use screwdriver to prise
out interior mirror on left
side between mounting
plate -7- and mirror base
-3-.
– Detach interior mirror.
Installing
– Prior to installation,
check that locking pin
-8- is engaged.
– Guide wire -4- through
mirror base opening in
frame for front roof mod‐
ule.
– Insert right side of mirror
base -3-.
– Clip in mirror base trim
-2- on right side.
– On left side, press mirror
base trim -2- with mirror
base -3- upwards until locking pin -8- engages.
– Plug in connector of wire -4- at roof module.
– Install roof module (front) ⇒ Electrical system; Rep. gr. 96 .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
92 Rep. gr.68 - Interior equipment