Audi A8 2003 - Front seat covers and padding (memory seat, electrically operated seat)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.13 Removing and installing side trim on sill panel side
1 - Connector
2 - Clip
3 - Connector
4 - Side trim, sill panel side
♦ Removing
– Remove the seat pan
⇒ page 342 .
– Disengage the front trim
-8- at the location
marked with an arrow
from the side trim on the
sill panel side -4-.
– Unscrew the bolts -5-
(3x).
– Use a screwdriver to
prise the clip -2- out of
the side trim on the sill
panel side -4-.
– Unplug the connectors
-1- and -3-.
– Pull off the side trim on
the sill panel side -4- to
the rear.
♦ Installing
– Install the side trim on
the sill panel side -4- in
the reverse order of re‐
moval.
– Make sure the wiring
harness -6- is posi‐
tioned behind the fas‐
tening strip -7-.
5 - Bolts (3x)
❑ Tightening torque 2.5
Nm.
6 - Wiring harness
7 - Fastening strip
8 - Front trim
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Electrically operated individual rear seats 349