Audi A8 2003 - Removing and Installing Lower Backrest Cover Panel

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.27 Removing and installing lower backrest cover panel
1 - Clips (2x)
2 - Clip
3 - Holder (2x)
4 - Holder (2x)
5 - Lower backrest cover panel
♦ Removing
– Remove the upper
backrest cover panel
⇒ page 309 .
– Unfasten the clips -1-
(2x): Insert a flat screw‐
driver in the clip and turn
it clockwise until the clip
is released.
– Unfasten the clip -2-: In‐
sert a flat screwdriver in
the clip and turn it clock‐
wise until the clip is re‐
leased as far as the first
detent.
– Use a flat screwdriver to
push the clip -2- to the
left until the backrest
cover panel -5- is re‐
leased.
– Disengage the backrest
cover panel -5- upwards
from the holders -3- (2x)
and -4- (2x).
♦ Installing
– Replace the clips -1-
(2x) and -2- if damaged.
– Guide the clip -2- into
the clip holder.
– Fit the backrest cover
panel in the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
310 Rep. gr.72 - Seat frames