Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
14 Child seat anchor (USA, Canada)
14.1 Removing and installing child seat an‐
chor
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1331-
1 - Outer trim cap
❑ Pull out of rear shelf
❑ To install, place in posi‐
tion at rear and press
downwards at front
2 - Anchor
♦ Removing
– Screw out the bolt -3-.
– Take out the anchor.
♦ Installing
Install in reverse order.
3 - Bolt, 23 Nm
4 - Spacer sleeve
5 - Holder
❑ For centre anchor
6 - Rear shelf cross member
7 - Centre trim cap
❑ Pull out of rear shelf
❑ To install, place in posi‐
tion at rear and press
downwards at front
8 - Rear shelf
9 - Holder
❑ For outer anchor
10 - Bolt, 23 Nm
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
174 Rep. gr.69 - Passenger protection
To Next Page
Loading...
