Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press the button -3- from inside out of the head restraint -1-.
– Pull out the trim plate -2-.
♦ Installing
– Install the slide-in locking mechanism in the reverse order of
removal.
2.12 Removing and installing backrest mat
♦ Removing
– Remove the rear seat bench ⇒ page 333 .
– Remove the rear seat backrest ⇒ page 334 .
– Use a screwdriver to prise out the fastening strip -4-.
– Disengage the top of the backrest mat -2- at the studs -1- (2x).
– Disengage the bottom of the backrest mat -2- at the holders
-3- (2x).
– Take out the backrest mat -1-.
♦ Installing
– Install the backrest mat -1- in the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
340 Rep. gr.72 - Seat frames
To Next Page
Loading...
