Audi A8 2003 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press on the gas generator -16-.
– Make sure the threaded pin -8- is in contact with the rear stop of the elongated hole -10-.
– Tighten the nuts -7- and -15-.
– Tighten the nut -13- at the holder -12-.
– Consecutively tighten the nuts -13- (5x).
– Secure the wiring harness -2- at the clip -1-.
WARNING
There must not be any‐
one in the vehicle when
connecting the battery.
– With the ignition switched on, connect the battery earth wire ⇒ Electrical system; Rep. gr. 27 .
Note
If the airbag warning lamp -K75- in‐
dicates a fault following installation,
the event recorder must be interro‐
gated, erased and interrogated
again ⇒ Vehicle diagnostic tester.
12 - Holder
13 - Nuts (6x)
❑ Tightening torque 5.5 Nm.
14 - Stud
15 - Nut
❑ Tightening torque 5.5 Nm.
16 - Gas generator
17 - Holder
7.2 Removing and installing rear deforma‐
tion element (Saloon)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
144 Rep. gr.69 - Passenger protection

Audi A8 2003 Specifications

General

Brand	Audi
Model	A8 2003
Category	Automobile
Language	English