Audi A8 2003 - Separating Luggage Compartment Side Trim and Drip Rail Trim;Assembling; Removing and Installing Back Panel Trim

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Pull the ventilation grille -1- with the front end hook -3370- out
of the luggage compartment side trim -2- in -arrow direction-
on the side facing forwards.
– Detach the channel section of the ventilation grille in the di‐
rection of travel from the luggage compartment side trim -2-.
– Take out the ventilation grille.
Installing
Install in reverse order.
6.27 Separating luggage compartment side
trim and drip rail trim/assembling
Removing
– Remove the luggage compartment side trim ⇒ page 273 .
– Remove the speed nuts -3- (3x).
– Detach the drip rail trim -1- from the luggage compartment side
trim -2-.
Installing
Install in reverse order, paying attention to the following:
♦ Use new speed nuts (3x).
6.28 Removing and installing back panel trim
Special tools and workshop equipment required
♦ Removal wedge -3409-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
6. Trim panels 275