Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Back panel trim
♦ Removing
– Remove the luggage
compartment floor cov‐
ering ⇒ page 277 .
– Remove the lower rear
shelf trim ⇒ page 278 .
– Use a flat screwdriver to
prise out the caps -3- of
the expanding clips -2-
(7x).
– Remove the expanding
clips -2- (7x).
– Pull the back panel trim
-1- out from under the
frame of the ski bag -4-.
– Take out the back panel
trim.
♦ Installing
Install in reverse order. Pay at‐
tention to the following:
♦ Replace damaged expand‐
ing clips -2- and caps -3-.
♦ At the start of assembly,
jam the back panel trim be‐
neath the frame of the ski
bag. To do so, make use of
the removal wedge -3409-
if necessary.
♦ Take care to avoid creases
at the back panel trim.
2 - Expanding clips (7x)
❑ Replace if damaged
3 - Cap (7x)
❑ For expanding clip -2-
❑ Replace if damaged
4 - Ski bag
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
276 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
