Audi A8 2003 - Removing and Installing Sliding Cover for Large Storage Compartment; Removing and Installing Sockets in Large Storage Compartment

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove extension for centre console ⇒ page 59 .
– Unscrew bolt -3-. 2.5 Nm
– Unscrew bolts -2- (6x). 2.5 Nm
– Take out large storage compartment -1- downwards.
3.10 Removing and installing sliding cover for
large storage compartment
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
Removing
– Remove extension for centre console ⇒ page 59 .
– Remove large storage compartment ⇒ page 63 .
– Slacken off bolts -6- (2x) by a few turns.
– Release tabs -4- (2x) in direction of arrow.
– Pull out sliding cover -3- downwards.
Installing
– Insert sliding cover -3- from bottom.
– Pull sliding cover -3- forwards as far as it will go (completely
close large storage compartment).
– Clip in tabs -4- at lugs -5-.
– Tighten bolts -6-.
1 - Storage compartment (large)
3.11 Removing and installing sockets in large
storage compartment
Special tools and workshop equipment required
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
64 Rep. gr.68 - Interior equipment