Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7 - Bolt, 2 Nm
❑ 2x per moulded recess
8 - Grip moulding
❑ Removing and installing ⇒ page 271
9 - Speed nut
❑ 8x per grip moulding
❑ Always replace after removing
10 - Clip
❑ 12x
❑ Replace if damaged
11 - Emergency release handle
❑ For USA only
❑ Removing and installing ⇒ page 270
12 - Grip moulding
❑ For USA only
❑ Clipped into rear trim
13 - Luggage compartment light
❑ Removing and installing: ⇒ Electrical system; Rep. gr. 96 .
14 - Rear lid
6.20 Removing and installing emergency re‐
lease handle
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Removing
– Unclip the cover -1-.
– Screw out the bolt -4-.
– Pull off the handle -2-.
3 - Moulded recess clipped into rear lid trim
Installing
Install in reverse order.
Tightening torque:
Handle to moulded recess: 4.5 Nm
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
270 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
