Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4 Servicing driver side airbag -N95-
Block diagram
♦ ⇒ „4.1 Removing and installing driver side airbag unit N95 “,
page 123
♦ ⇒ „4.2 Removing and installing steering wheel“, page 126
♦ ⇒ „4.3 Removing and installing airbag coil connector and re‐
turn ring with slip ring F138 “, page 128
4.1 Removing and installing driver side air‐
bag unit -N95-
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410/-
Note
♦
The airbag unit removal and installation operations are the
same for all steering wheel versions.
♦
The only difference between the airbag units is the number of
connectors:
♦
Plug for coil connector and - as additional equipment - con‐
nector for multi-function steering wheel
♦
Removal and installation are described on the basis of a heat‐
ed 4-spoke multi-function steering wheel with Tiptronic.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
4. Servicing driver side airbag N95 123
To Next Page
Loading...
