Audi A8 2003 - Removing and Installing Floor Covering Rod (Rear and Front); Removing and Installing Air Conditioner Operating Unit (Front)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.4 Removing and installing floor covering
rod (rear and front)
Removing
– Pull floor covering out of rods at front and rear.
– Unclip floor covering rods from centre console.
Installing
Note
Always start by fitting rear left or right floor covering rod.
– Position rods -1- and -2- on floor covering -3-.
– Make sure floor covering -3- is correctly positioned in clips
-5-.
– Attach rods -1- and -2- to centre console -4-.
– Press floor covering -3- into position. Rods must engage in
centre console clips -5-.
2.5 Removing and installing air conditioner
operating unit (front)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783/-
Removing
– Move selector lever to „S“.
– Switch off ignition.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Removing and installing centre console without extension 29