Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connector -1- for glove box wiring harness
-2- from supply lead -3-.
– On vehicles with knee airbag: Pull catch -2- in direction of ar‐
row and unplug electrical connectors -1- and -3-.
– Remove glove box.
Installing
Installation is carried out in reverse order; note the following:
– With ignition switched on, connect battery earth wire ⇒ Elec‐
trical system; Rep. gr. 27 .
Tightening torque:
Glove box to dash panel: 4 Nm
1.3 Removing and installing glove box lid
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783/-
Removing
– Remove glove box ⇒ page 3 .
– Pull pivot pin -1- out of cushioning mechanism for glove box
lid.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Shelves / trim panels 7
To Next Page
Loading...
