Audi A8 2003 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove storage compartment (driver's side) ⇒ page 10 .
– Destroy expanding section -arrows- of pivot pin -2-.
– Pull pivot pin -2- out of mounting.
– Take storage box -3- out of storage compartment (driver's
side) -1-.
Installing
Installation is carried out in reverse order; note the following:
– Renew pivot pins.
– Make sure pivot pins engage fully.
1.8 Removing and installing steering col‐
umn trim
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
♦ Special screwdriver T8 -T40056 A-
Removing
– Lower steering wheel as far as possible towards rear, making
use of the full range of the steering column adjuster.
– Remove airbag unit and steering wheel ⇒ page 123 .
– Remove storage compartment (driver side) ⇒ page 9 .
Vehicles with mechanically adjustable steering column
– Slacken off bolt -2-.
– Detach handle -1-.
3 - Steering column trim
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
12 Rep. gr.68 - Interior equipment

Audi A8 2003 Specifications

General

Brand	Audi
Model	A8 2003
Category	Automobile
Language	English