Audi A8 2003 - Removing and Installing Electrically Operated Head Restraint; Removing and Installing Electrically Operated Head Re- Straint

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.32 Removing and installing electrically operated head restraint
1 - Clips (2x)
2 - Head restraint
♦ Removing
– Remove the upper
backrest cover panel
⇒ page 309 .
– Remove the lower back‐
rest cover panel
⇒ page 310 .
– Use a screwdriver to pull
back the clips -1- (2x) on
the open side.
– Move the backrest to the
rear.
– Lift out the head re‐
straint -2-.
♦ Installing
– Install the head restraint
-2- in the reverse order
of removal.
– Electrically operated
head restraints with
memory: For re-adap‐
tion of the head restraint
stop, move the head re‐
straint to the bottom and
then the top position
once.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Front seats (memory seat, electrically operated seat) 315