Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Turn the knurled wheel -3- of the left air vent above the glove
compartment fully up.
– Above the bottom slat -2-, insert a jeweller's screwdriver -1- in
each of the two air vent clips.
– Alternately pull the left and right side of the air vent out of the
installation opening, leaving the jeweller's screwdrivers in po‐
sition.
Note
If necessary, use a hook -3438- to pull the air vent out of the
opening.
– Unplug the connector at the air vent.
– Repeat the procedure at the air vent on the right next to the
dash panel insert.
– Prise off the trim panel at the bottom left and right edge using
the removal wedge - 3409- -arrow 1-.
– Pull the trim panel downwards out of the display unit lugs
-arrow 2-.
Installing
Install in reverse order.
3.7 Removing and installing trim panel
above glove compartment
Special tools and workshop equipment required
♦ Removal wedge - 3409-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Dash panel 217
To Next Page
Loading...
