Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installing
– Align the pins -2- of the hook -1- with the holes in the door
frame -3-.
– Position the hook -1- on the door frame.
– Press in the pins -2- until they engage.
2.18 Removing and installing electric sun
blind
2.18.1 Removing and installing housing for
electric sun blind
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Removing
– Remove the door trim ⇒ page 189 .
– Remove the insulation ⇒ page 192 .
– Sun blind removal involves setting it to service mode. To do
so, use the switch in the roof module to unwind the sun blind
in the rear door.
Note
Moving electric sun blind with defective drive unit ⇒ page 203 .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
200 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
