Audi A8 2003 - Rear seat covers and padding

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.1 Removing and installing seat pan cover
and padding (sports seat)
1.1.1 Separating cover and padding from seat pan
1 - Fastening strip
2 - Cover and padding
♦ Removing
– Remove the seat
⇒ page 282 .
– Attach the holder for
seat repair -VAS 6136-
to the engine and gear‐
box holder -VAS 6095- .
– Attach the front seat to
the holder for seat repair
-VAS 6136- .
– Remove the side trim on
the sill panel side
⇒ page 292 .
– Remove the side trim on
the tunnel side
⇒ page 293 .
– Remove the front trim
⇒ page 293 .
– Remove the holder for
the seat side trim panels
⇒ page 294 .
– Remove the backrest
⇒ page 288 .
– Use a screwdriver to
prise out the fastening
strip -1-.
– Disengage the fastener
-5- from the holders -6-
(2x).
– Disengage the fastening strips -7- (3x) from the fastener -5-.
– Disengage the lugs -4- (2x) from the fastener -5-.
– Guide the tensioning wires -4- (2x) out of the cover tabs -3- (2x).
3 - Cover tabs (2x)
4 - Tensioning wires with lugs (2x)
5 - Fastener
6 - Holder (2x)
7 - Fastening strips (3x)
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
360 Rep. gr.74 - Seat - padding, covers