Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Move selector lever to „S“.
– Switch off ignition.
– Open ashtray (front).
– Press button -arrow-.
– Pull out ashtray insert -1-.
– Remove bolt -1-.
– Pull ashtray (front) -2- out of centre console.
– Unplug electrical connector.
Installing
Install in reverse order of removal.
Tightening torque:
Ashtray (front) to centre console: 4 Nm
2.7 Renewing trim for ashtray (front)
Removing
– Remove ashtray (front) ⇒ page 31 .
– Press lug -1- out of spring clip -2-.
– Detach trim -3-.
Installing
– Position upper edge of trim -1- on tabs -3- of ashtray cover
-2-.
4 - Pin
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
32 Rep. gr.68 - Interior equipment
To Next Page
Loading...
