Audi A8 2003 - Removing and Installing Rear Left Seat Lumbar Support Height Adjustment Motor V225 and V225

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.24 Removing and installing rear left seat lumbar support height adjustment
motor -V225- and -V225-
1 - Bowden cable
2 - Clip
3 - Fastening strip
4 - Rear left seat lumbar sup‐
port height adjustment motor -
V225- and -V225-
♦ Removing
– Remove the seat pan
⇒ page 342 .
– Remove the individual
rear seat ⇒ page 343 .
– Unplug the connector
-5-.
– Disengage the Bowden
cable -1- from the clip
-2-.
– Prise out the lock wash‐
er -6-.
– Disengage the Bowden
cable -1- at the hook
-7-.
– Unscrew the bolt -8-.
– Take out the lumbar
support height adjust‐
ment motor -4-.
♦ Installing
– Install the lumbar sup‐
port height adjustment
motor -4- in the reverse
order of removal.
5 - Connector
6 - Spring lock washer
7 - Hook
8 - Bolt
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Electrically operated individual rear seats 357