Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Unclip the cap -1- with a 0.35 mm feeler gauge -2- from the
centre defroster vent -arrow-.
– Prise out the sunlight penetration photosensor -G107-
-Item 3- and unplug the connector.
– Screw out the bolt -1-.
– Prise the centre defroster vent -2- as shown out of the dash
panel using the removal wedge -3409- .
– Screw out the bolts -2-.
– Detach the indirect ventilation trim panel -1-.
Installing
Install in reverse order, paying attention to the following:
– Make sure the clips -3- engage in the dash panel mounts.
Tightening torque:
Indirect ventilation trim panel to dash panel: 2 Nm
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
222 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
