Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Installing
– Install the cover and padding -11- in the reverse order of removal.
– To fit new upholstery clips -7- use the upholstery clip pliers V.A.G 1634.
3.2.2 Separating cover from padding
Special tools and workshop equipment required
♦ Awl -V.A.G 1636 A-
1 - Awl -V.A.G 1636 A-
2 - Fastener
3 - Plastic clips
4 - Backrest frame
5 - Rubber elements (2x)
6 - Side fastening strips (6x)
7 - Upholstery clips (4x)
8 - Lower fastening strips (5x)
9 - Backrest heating connector
10 - Fastening strip
11 - Cover and padding
♦ Removing
♦ Use an awl -V.A.G 1636 A-
-1- to carefully prise the fas‐
teners -2- out of the plastic
clips -3-.
♦ Detach the cover from the
padding.
♦ Installing
– Fit the cover in the re‐
verse order of removal.
– Replace damaged plas‐
tic clips -3-.
– Start by pressing the
fasteners -2- of the
transverse rods into the
plastic clips -3-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Covers and padding for electrically operated individual rear seats 381
To Next Page
Loading...
