Audi A8 2003 - Page 196

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Hinged pocket with mount
♦ Removing
– Remove the door trim
⇒ page 176 and
⇒ page 176 .
– Remove the insulation
⇒ page 176 and
⇒ page 181 .
– Unscrew the bolts -4-
(8x).
– Unscrew the bolts -3-
(6x).
– Unclip the connector
guide -6- from the door
trim -2-.
– Unplug the connector
-5-.
– Detach the connector
guide -6- from the con‐
nector -5-.
– Take out the hinged
pocket with mount -1- on
the front side of the door
trim -2-.
♦ Installing
– Install the hinged pocket
with mount -1- in the re‐
verse order of removal.
2 - Door trim
3 - Bolts (6x)
❑ Tightening torque 2 Nm.
4 - Bolts (8x)
❑ Tightening torque 2 Nm.
5 - Filler neck compartment lid/
rear lid release switch module
connector
6 - Connector guide
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
186 Rep. gr.70 - Trim, insulation