Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1331-
Removing:
Note
The buckle for the seat-occupied sensor for front passenger's air‐
bag deactivation is only fitted on the front passenger's seat.
WARNING
The buckle for the seat occupied sensor for front passenger's
airbag deactivation is always to be replaced following trigger‐
ing of the front passenger's belt tensioner.
– Remove the seat ⇒ page 282 .
– Remove the side trim on the tunnel side -1- ⇒ page 293 .
– Disconnect the wiring harness -3- at the connector leading to
the wiring harness of the seat occupied recognition control unit
-J706- and unfasten the clip at the seat.
– Screw out the bolt -2- with which the buckle -6- is attached and
detach the buckle -6-.
Installing:
♦ Install in reverse order. Pay attention to the following when
doing so.
– Replace the buckle attachment bolt.
– When fitted, the lug at the buckle -4- must be positioned in the
recess -5- of the seat.
Note
If the buckle for the seat-occupied sensor for front passenger's
airbag deactivation is replaced, the report form for the seat-oc‐
cupied sensor with the serial number and bar code sticker of the
new buckle must be completed and sent to the importer.
Tightening torque:
Component Nm
Bolt for buckle attachment 34
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Seat belts 117
To Next Page
Loading...
