Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Move the steering wheel down and to the rear as far as pos‐
sible, making use of the full range of the steering column
adjuster.
– Switch off the ignition and remove the ignition key.
– Carefully separate the trim panel -1- from the dash panel using
the removal wedge -3409- -arrows-.
– Open the coin tray.
– Slide the trim for the coin tray to the left out of the fastener
-arrow- and detach.
– Open the glove compartment.
– Starting from above the glove compartment, carefully separate
the trim panel -1- with switch module from the dash panel using
the removal wedge -3409- .
– Detach the trim panel with switch module in -arrow direction-.
Note
Take particular care when releasing the clip at the driver side end
of the trim panel.
– Unplug the connector.
– Turn the knurled wheel -3- of the air vent on the left next to the
dash panel insert fully upwards.
– Above the bottom slat -2-, insert a jeweller's screwdriver -1- in
each of the two air vent clips.
– Alternately pull the left and right side of the air vent out of the
installation opening, leaving the jeweller's screwdrivers in po‐
sition.
Note
If necessary, use a hook -3438- to pull the air vent out of the
opening.
– Unplug the connector at the air vent.
– Repeat the procedure at the air vent on the right next to the
dash panel insert.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Dash panel 215
To Next Page
Loading...
