Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1783-
WARNING
Heed the safety regulations for pyrotechnic components
⇒ page 94 .
1 - Nuts (2x)
❑ Tightening torque 4 Nm
2 - C-pillar trim
♦ Removing
– Remove the D-pillar trim
⇒ page 258 .
– Unscrew the nuts -1-
(2x).
– Remove the narrow D-
pillar trim ⇒ page 260 .
– Detach the C-pillar trim
-2- inwards.
♦ Installing
– Install the C-pillar trim
-2- in the reverse order
of removal.
WARNING
Make sure the trim is a
firm fit.
– Make sure the rubber
door seal is properly fit‐
ted over the C-pillar trim.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
6. Trim panels 257
To Next Page
Loading...
