Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
WARNING
Heed the safety regulations for pyrotechnic components
⇒ page 94 .
1 - Clips (2x)
2 - Bolt
❑ Tightening torque 4 Nm
❑ Self-locking
❑ Replace
❑ The tapped holes for the
bolts must always be
cleaned (e.g. with a
thread cutter).
3 - Upper D-pillar trim
♦ Removing
– Remove the roof grab
handle ⇒ page 251 .
– Remove the coat hook
⇒ page 260 .
– Unscrew the bolt -4-.
– Unclip the upper A-pillar
trim in the area of the D-
pillar trim.
– Unscrew the bolt -2-.
– Unfasten the upper D-
pillar trim -3- at the clips
-1- (2x).
– Pull out the upper D-pil‐
lar trim -3- inwards.
♦ Installing
– Install the D-pillar trim
-3- in the reverse order
of removal.
WARNING
Make sure the trim is a
firm fit.
– Make sure the rubber door seal is properly fitted over the D-pillar trim.
4 - Bolt
❑ Tightening torque 4 Nm
❑ Self-locking
❑ Replace
❑ The tapped holes for the bolts must always be cleaned (e.g. with a thread cutter).
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
6. Trim panels 259
To Next Page
Loading...
