Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the upper backrest cover panel ⇒ page 309 .
– Remove the lower backrest cover panel ⇒ page 310 .
– Slacken off the bolt of the backrest adjustment motor
⇒ page 308
– Use a screwdriver to prise off the lock washer -5- on the back‐
rest motor side (detail view -B-).
– Use a hammer and punch to knock the shaft -4- through the
side of the backrest frame.
– Pull the shaft -4- out of the backrest frame -1- until the backrest
adjustment motor is released.
♦ Installing
– Align the splines of the new backrest adjustment motor
⇒ page 309
– Slide the shaft -4- through the backrest adjustment motor and
the backrest frame -1-.
– Move the seat aside.
– On the opposite side of the backrest adjustment motor, place
a wooden block -2- beneath the shaft -4- (detail view -A-).
– Use an 11 mm socket attachment to knock the spring lock
washer -5- onto the shaft -4- (detail view -C-).
– Screw on the bolt at the backrest adjustment motor and plug
in the connector.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Front seats (memory seat, electrically operated seat) 307
To Next Page
Loading...
