Audi A8 2003 - Page 170

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
WARNING
The replacement part (service kit) for the seat-occupied sensor
is already pre-calibrated and is never to be separated. The
service kit consists of the:
♦ Seat occupied recognition control unit -J706-
♦ Pressure sensor for seat occupied recognition -G452-
♦ Seat occupied sensor mat
♦ Seat padding
♦ Wiring harness
WARNING
The seat cover must also be replaced on replacing the service
kit in the A8. The seat cover must be ordered separately.
– Replace damaged components.
Note
2 rigid foam inserts are bonded on the seat pan -1- beneath the
seat-occupied sensor mat -6-. The rigid foam inserts are required
for correct functioning of the system. The rigid foam inserts are
not part of the scope of delivery of the service kit. Replace the
rigid foam inserts if damaged ⇒ page 161 .
– The tabs -4- (2x) at the seat-occupied sensor mat -6- must be
positioned above the cross-piece -5-.
– The anti-squeak pad must be laid without creases between the
seat-occupied sensor mat -6- and the seat foam -2-.
– Position the pressure hose -1- in line with the mark -2- in the
holder -3-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
160 Rep. gr.69 - Passenger protection