Audi A8 2003 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
♦ The left and right side airbags can only be jointly activated.
Individual side airbag activation is not possible.
♦ One connector each is provided on the left and right on the sill
panel side of the seat frame.
– Cut through the connector cable ties.
– Fit the connector for the side airbag -1-.
Vehicles with no curtain airbag
– Remove the rear wheel housing trim ⇒ page 258 .
– Fit the crash sensor connector at the C-pillar ⇒ page 169 .
– Install the rear wheel housing trim ⇒ page 258 .
All vehicles
– Remove the seat pan ⇒ page 342 .
– Remove the side airbag deactivation stickers from the rear
door frames.
– Use cleaning agent to remove any residual adhesive from the
door frames.
– Alter the encoding of the airbag control unit to the option with
rear side airbag ⇒ Vehicle diagnostic tester.
– Complete the registration card and forward it to the appropri‐
ate Regional Sales Centre or importer for recording purposes.
Remove Sheet 3 of the registration card from the customer's
document wallet.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
11. Deactivation of rear side airbag with individual electrically operated rear seats 165

Audi A8 2003 Specifications

General

Brand	Audi
Model	A8 2003
Category	Automobile
Language	English