Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Remove the rear seat bench ⇒ page 333 .
– Screw out the bolts -2- and -3-.
– Take out the ISOFIX holder -1-.
4 - Rear seat backrest
Installing
Install in reverse order, paying attention to the following:
– Replace the bolts if the ISOFIX holder was removed as part of
servicing work following an accident
Tightening torques
♦ Bolt -2-: 40 Nm
♦ Bolt -3-: 55 Nm
13.1.2 Removing and installing centre ISOFIX
holder
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1331-
♦ Torque wrench -V.A.G 1332-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
172 Rep. gr.69 - Passenger protection
To Next Page
Loading...
