Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Door trim
♦ Removing
– Remove the trim panel
-3- ⇒ page 178 .
– Unscrew the bolt -2-.
– Close the hinged pocket
-5-.
– Unscrew the bolt -4-.
– Starting at the bottom,
unfasten the door trim
-1- at the clips -6- (8x).
– Disengage the Bowden
cable for the interior
door handle
⇒ page 177
– Unplug the connector at
the window regulator
control unit
⇒ page 178 .
♦ Installing
– Make sure all the clips
-6- are in position on the
back of the door trim.
Replace damaged clips
⇒ page 178
– Install the door trim -1- in
the reverse order of re‐
moval.
2 - Bolt
❑ Tightening torque 4 Nm.
3 - Trim panel
4 - Bolt
❑ Tightening torque 4 Nm.
5 - Hinged pocket with mount
6 - Clips (8x)
7 - Door shell
Disengaging Bowden cable for interior door handle
– Pull the Bowden cable -2- out of the guide -1-.
– Disengage the hook -3-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Front door trim panels 177
To Next Page
Loading...
