Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– If applicable, remove the CD changer as follows:
– Insert 2 keys of the radio release tool -T10057- in the front of
the CD changer.
♦ Top L - top left
♦ Top R - top right
– Pull the CD changer out of the mounting frame.
– Unplug the connector.
– Unplug the fibre optic cable connector.
– Seal the open wiring harness connector -2- of the fibre optic
cable with the protective cap -VAS 6223/9- -Item 1-.
Note
The protective cap prevents contamination of or mechanical dam‐
age to the end face of the fibre optic cable which would impair
light transmission.
– Press the catches at the CD changer and pull the release tool
out of the CD changer.
– If applicable, remove the storage compartment in the glove
compartment. To do so, use a small screwdriver to release the
retainer tabs -1- and -2- in -arrow direction-.
– Pull the storage compartment out of the glove compartment.
– Screw out the bolts -arrows-.
– Screw out the bolts -1- and -2-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Dash panel 227
To Next Page
Loading...
