Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Open coin holder.
– Slide trim for coin holder to left out of fastener -arrow- and
detach.
– Open glove box.
– Starting from above glove box, carefully separate trim panel
-1- with switch module from dash panel using removal wedge
-3409- .
– Detach trim panel with switch panel in direction of -arrow-.
Note
Take particular care when unfastening clip at end of trim panel
closest to driver.
– Unplug electrical connector.
– Turn knurled wheel -3- of left air vent above glove box fully up.
– Above bottom slat -2-, insert jeweller's screwdriver -1- in each
of the two air vent clips.
– Alternating between left and right side, pull air vent out of
opening, taking care to ensure that jeweller's screwdrivers re‐
main in position.
Note
If necessary, use hook -3438- to pull air vent out of opening.
– Unplug connector at air vent.
– Release retaining tabs -1- of coin holder.
– Pull coin holder out of dash panel -arrow-.
– Unplug connector on back of coin holder.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
14 Rep. gr.68 - Interior equipment
To Next Page
Loading...
