Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1783-
♦ Removing
– Use a screwdriver to prise out the cover panels -3- (2x) from
underneath.
– Unscrew the bolts -2- (2x).
♦ Tightening torque 4 Nm.
– Detach the roof grab handle -1-.
♦ Installing
Note
♦
Remants of locking fluid are always to be removed from the
tapped holes for the roof grab handle after removing the roof
grab handle. Otherwise there would be a danger of the new
bolts seizing when screwed in and shearing off on renewed
disassembly.
♦
Cleaning can be performed using a thread cutter.
♦
Replace the roof grab handle bolts (self-locking).
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
252 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
