Audi A8 2003 - Page 265

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Holder (2x)
2 - Upper B-pillar trim
♦ Removing
– Unclip the lower B-pillar
trim in the area of the
upper B-pillar trim.
– Unscrew the nuts -6-
(2x).
– Pull out the upper B-pil‐
lar trim -2- downwards.
– Complete removal: Re‐
move the outer anchor‐
age point ⇒ page 107
and guide out the web‐
bing -7-.
♦ Installing
WARNING
Always keep to the upper
B-pillar trim installation
sequence.
– Complete removal: Fit
the outer floor group an‐
chorage point
⇒ page 107 and guide in
the webbing -7-.
– Engage the upper B-pil‐
lar trim -2- at the holders
-1- (2x).
– Make sure the retainer
-4- engages in the
mount -5- at the belt
height adjuster.
– Press on the upper B-pillar trim -2-.
– Screw in the nuts -6- (2x).
WARNING
Make sure the trim is a
firm fit.
– Make sure the rubber door seal is properly fitted over the upper B-pillar trim.
– Check operation of the belt height adjuster.
3 - Clips (2x)
4 - Retainer at upper B-pillar trim
5 - Mount at belt height adjuster
6 - Nuts (2x)
7 - Webbing
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
6. Trim panels 255