Audi A8 2003 - Page 310

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1331/-
1 - Rivets (4x)
2 - Bolts (8x)
❑ Tightening torque 20
Nm
3 - Seat pan
4 - Lower seat pan frame
5 - Upper frame of seat pan
with seat height adjustment
motor
♦ Removing
– Remove the seat
⇒ page 282 .
– Attach the holder for
seat repair -VAS 6136-
to the engine and gear‐
box holder -VAS 6095- .
– Attach the front seat to
the holder for seat repair
-VAS 6136- .
– Remove the side trim on
the sill panel side
⇒ page 292 .
– Remove the side trim on
the tunnel side
⇒ page 293 .
– Remove the front trim
⇒ page 293 .
– Remove the holder for
the seat side trim panels
⇒ page 294 .
– Remove the backrest
⇒ page 288 .
– Remove the seat pan
cover and padding
⇒ page 360 .
– Remove the control unit
⇒ page 295 .
– Remove the connector point ⇒ page 296 .
– Remove the belt buckle ⇒ page 116 .
– Drill out the rivets -1- (4x).
– Unscrew the bolts -2- (8x).
– Unfasten the wiring harness and unplug the connectors from the seat pan and motors.
– Replace the upper frame of the seat pan -5-.
♦ Installing
– Install the upper frame of the seat pan -5- in the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
300 Rep. gr.72 - Seat frames